After packing steel belt furnace tapping machine is how to work?

After packing steel belt furnace tapping machine is how to work? Answer: the existing continuous furnace furnace after discharging method, usually will be hot slab along with a certain slope of the straight board or arc slide to the roller, roller lateral has a buffer, absorbing kinetic energy of slab along the slide down. With the increase of the slab quality, some even rolling mill has been tapping machine is used to remove the slab. For domestic 1700 mm HSM machine furnace after the profile steel machine. Tapping machine by four out of the mobile mechanism of steel bar and the lifting mechanism of steel bar. When good slab furnace heating, by pushing steel machine in front of the furnace or step by step to move the steel body, after moved to the location of the slab end point control device, a steel rod 1 under the motor drive, through reducer and rack and pinion mechanism into the furnace, parked under the slab. 2, and then start the rotation of the eccentric wheel motor through the worm gear reducer, drives the eccentric eccentric 4 for 50 mm, raise the steel bar 1, make the hot slab is lifted and slides from the oven. The steel bar, motor start pulling steel rod carried the slab furnace, moved to the table above. Then start the motor 2 again, use the steel bar down to about 70 mm below the roller surface, thus will the slab on the table.