Bluing clad steel belt production line operation

Bluing dozen steel belt is to use chemicals such as sodium nitrate to metal surface oxidation at high temperature for oxide, formed more resistant to corrosion protection layer of steel belt. In bluing clad steel belt production of specific steps are as follows: 1. Start the bluing clad steel belt winding machine, will speed values to process, adjust the winding spiral distance. 2. After they start 120 extrusion machine, extrusion chip speed values to process. Then chip winding on the roll bonding together, adjust the width of the chip bonding, open the cooling water inside. 3. Connect the traction rope bluing clad steel belt, two laps on a chip. 4. Start 90 extruder, covering the outer material on steel band, taut drawing rope, again at the same time start the machine, bending machine, feeding machine, set the linear velocity to process value. 5. Start the high frequency induction heating equipment, adjust current, open the hot air heated the steel belt. 6. Will be the first group of roller on the outer layer material of bluing baotou steel wear, adjust the tension device of air pressure, to ensure the degree of compaction of the strip. 7. Adjusting prestressing degree of the second set of roller, to ensure that the outer layer material and bluing clad steel belt bonding tightly 8, pipe pull out a meter long, the exposed steel strip cutting off, lest the roof into the room. 9. Open cooling water, spray from the discharging mouth four or five ripples on the pitch. 10. When pull tubing to the pipes of the position, adjust the height and broadband pipes, to adapt the demand of different pipe specification.