Packaging technical requirements for packaging steel strips

Pad outsourcing board
　　 Lay the outsourcing board flat on the packaging stand, the packaging stand is placed in parallel by two stows, and the spacing is adjusted according to the actual width of the steel coil;
　　Packing technical requirements for packaging steel strips:
　　1 The width is equal to the strip width B or B+0 -50 mm.
　　2 The thickness of steel cladding is 0.4～0.6mm; the thickness of plastic cladding is 1.2～1.4mm.
　　3 The side with better surface quality is facing up;
　　4 When using plastic wrap, the wool side is up and the smooth side is down;
　　5 The overlap of the outer panel is 150～200mm.
　　 shop anti-rust paper;
　　 Spread the rust-proof paper that meets the specifications in the middle of the outsourcing board on the packaging platform;
　　 The two ends of the anti-corrosion paper are rolled up, and the middle part is opened, but not exceeding the length of a single wrapper board, to prevent stepping on the anti-corrosion paper, and at the same time, it is conducive to the neat and beautiful packaging site.
　　Packing steel belt operation and technical requirements:
　　Packed with a piece of anti-rust paper, the coated side of the anti-rust paper is facing up; the anti-rust paper is complete and flat, and no damage and wrinkles are allowed; the overlap amount of 300mm ≥ anti-rust paper> 150mm.
　　Related articles: What are the standards for the acceptance of packaging steel strips?