Packing steel strip manufacturers: reasons and troubleshooting methods for steel strapping machine failure

Due to the wear of parts during work, the loosening of screws and the reduction of air pressure, the steel strapping machine fails. Therefore, the strapping steel strap manufacturer recommends that it be eliminated in time to make the steel strapping machine work normally and smoothly. The reasons for the failure are as follows aspect. . In the air motor and cylinder block and all transmission and rotating parts, before each shift, an appropriate amount of lubricating oil must be injected. In addition, #气轮油 should be filled with #气轮油 in the lubricator regularly and quantitatively to maintain a fixed amount. The amount of oil supply, when the air motor is working, the oil dripping from the lubricator is-drop/min is the best. ????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????? . When the compressed air does not match .Mpa, it must be adjusted, otherwise, too low pressure will affect the quality of strapping, and too high pressure will cause the machine to wear out too quickly. . Oil injector and oil-water separator should be cleaned with kerosene every three months after use, and the accumulated water in the oil-water separator should be removed every day. . The gap between the friction wheel and the pad wheel is between .-.mm, otherwise it should be adjusted and the debris and dirt on the friction wheel should be removed in time. . Due to long-term wear of parts, environmental pollution, poor lubrication, failures may occur. Therefore, it is important to find failures and eliminate them in time. The following inspections and maintenance can be solved with general tools. Mastering the following technologies will not Due to minor failures, production will be stopped, precious time will be lost when the machine is shut down, and the packaging steel belt manufacturer will be asked for help. If you have more information about packing steel belts, you can click to view www. to learn more, I hope to help you.