Packing strip in the points of attention in the use

Packaging steel strip as a kind of industrial products, not only need to pay attention to in production, but also in the process of using need from several aspects to do, only in this way can make the quality of the products get better security. Packaging steel strip at the time of production: first, we will strictly control medium annealing is usually adopted by the pure hydrogen, and the purity needed in 99. More than 99%, which is quite strict. If it is inert gas, can be a little bit lower purity, but pay attention to the content of oxygen and moisture can't overweight. The second on the annealing temperature control, need to take solid solution heat treatment, in the process also need through the observation hole observation, it is need skills and experience, incandescent state is better. The first within the furnace on water vapor need often go to check, internal dry or not, especially the furnace charging for the first time, a bit more careful, the internal water vapor can never put too much. Fourth, sealed performance is good, each gap may soapy water on the stove, see if seal is absolutely good. Packaging steel strip in the process of use: when installed, be sure to is professional technicians to complete, and use special polyethylene pipes. Both luxurious decoration, and in general, should be to ensure that the quality is better, can use for a long time, to avoid crack and leakage, etc. , the loss caused by the time you can go to. Packaging steel strip after security must be pressure test, usually in 1. 5 times under the condition of water pressure, so can find if there are any leaks.