Points for attention in the use of packaging steel belts

As an industrial product, packaging steel belt not only needs attention during production, but also needs to be done in many aspects during use. Only in this way can the quality of the product be better guaranteed.
　　 When packaging steel strips are produced: First, the annealing medium must be strictly controlled. Usually pure hydrogen is used, and the purity needs to be above 99.99%. This requirement is quite strict. If it is an inert gas, the purity can be slightly reduced, but note that the oxygen and moisture content should not exceed the standard. Second, in the control of the annealing temperature, solution heat treatment is required. During this process, observation through the observation hole is required. This requires skill and experience. The incandescent state is better. The water vapor in the furnace needs to be checked frequently to see if the inside is dry, especially when the furnace is installed for the first time, so be careful. The water vapor inside must not be too much. Fourth, the sealing performance should be good. You can put soapy water on the gaps of the stove to see if the sealing performance is absolutely good.
　　In the process of using packaging steel belt: When installing, be sure to ask professional technicians to complete it, and use special polyethylene pipes. Regardless of whether it is luxurious decoration or general, it should be of good quality and long-term use to avoid bursts or leaks. At that time, the losses caused can be great. After the packaging steel belt is safe, a pressurization test must be carried out, usually under the condition of 1.5 times the water pressure, so that it can be found whether there is water leakage.