Strip break pack is not automatic analysis and solution

Why will not automatically take off belt? This is what causes? We need to pay attention to what? Please see the following analysis: first, automatic packer not cut with the following aspects: the knife bearing fracture. Check the reason, knife in the replacement of bearing wear. Both sides of the knife blade, or replace a new one side wear can exchange the other side is used. Second, the knife in the tube pin fracture. With a small punch out of the broken pin, into the new tube pin. Press a tuning package force is too tight. Adjustment nut above a hex bolts, set will adjust after loosen nut counterclockwise rotation, after set, will be hex socket set screw again. Third, skid or bundle with oil transmission belt. Remove the sliding piece of clean-up, dry and then assembled in sequence. Four, drive belt is too loose. Discover the timely replacement. Above to share that is packaged with no reason and the solution of automatic fault belt, everybody to learn, to avoid the above phenomenon when using straps.